Page 1 of 1

Access to ASIO COntrol panel from DAC or ADC Faceplate

PostPosted: Sat Nov 05, 2022 4:59 pm
by RJA4000
Hi

It's always difficult to set up ASIO4ALL configuration without a direct access to the ASIO config panel.
In general, I think that would be a great addition to add an access to the selected DAC/ADC ASIO config panel from Multi-Instrument's DAC or ADC device settings faceplate.

Do you think this is doable ?

Re: Access to ASIO COntrol panel from DAC or ADC Faceplate

PostPosted: Mon Nov 07, 2022 2:36 am
by VirtinsTech
Thanks for the suggestion! It will be added in the coming new version.

Re: Access to ASIO COntrol panel from DAC or ADC Faceplate

PostPosted: Fri Nov 11, 2022 7:07 am
by VirtinsTech
It has been included in the new release V3.9.7.0 which is now available for download. Thanks!

Re: Access to ASIO COntrol panel from DAC or ADC Faceplate

PostPosted: Sun Nov 13, 2022 7:27 pm
by RJA4000
It works in Build 3.9.7 !
Thanks !

Re: Access to ASIO COntrol panel from DAC or ADC Faceplate

PostPosted: Sat Dec 17, 2022 3:20 pm
by Kruger
Thank you! I really nice addition.

Re: Access to ASIO COntrol panel from DAC or ADC Faceplate

PostPosted: Mon Dec 19, 2022 1:24 am
by Kruger
Reverted back to 3.9.4
ASIO calibration is grayed out and cannot be changed.

Re: Access to ASIO COntrol panel from DAC or ADC Faceplate

PostPosted: Wed Dec 21, 2022 5:25 pm
by VirtinsTech
which ASIO driver was used when [Setting]>[Calibration]>"Others/ASIO" is grayed out? Is it miniDSP ASIO driver?

If "Others/ASIO" is grayed out when a particular ASIO driver is selected, it usually means that under that ASIO driver, the input gain is somehow still adjustable through "mixer" and the corresponding mixer gain percentage options will be enabled. Calibration should be done with respect to those options.

Re: Access to ASIO COntrol panel from DAC or ADC Faceplate

PostPosted: Fri Dec 23, 2022 4:00 am
by Kruger
Hi VirtinsTech,
Yes. It is exactly the miniDSP ASIO driver.
I will try to calibrate according to your advice.