Sound Card Oscilloscope Probe Kit P601PC - 1 channel
(US$29.95)
Probe kit for VIRTINS Sound Card Multi-Instrument series
Contains: 1 x Probe, 1 x 3.5 mm Stereo-to-2RCA converter, 1 x 3.5 mm Mono-to-1RCA converter and accessories
You may need from 1~4 sets of this probe kit per license of the software, depending on your purpose of test
We recommend the standard configuration be 2 sets per license
Stereo-to-2RCA converter's TRS plug pinout: Tip-left, Ring-right, Sleeve-common ground
Mono-to-1RCA converter's TS plug pinout: Tip-signal, Sleeve-common ground
Sound Card Oscilloscope Probe Kit P601PPC - 1 Channel
(US$34.95)
Probe kit for VIRTINS Pocket Multi-Instrument series
Contains: 1 x Probe, 1 x 3.5 mm HeadsetJack-to-3RCA converter and accessories
You may need 1 set of this probe kit and 1~2 sets of the probe kit for VIRTINS Sound Card Multi-Instrument
We recommend the standard configuration be 1 set of this probe kit (P601PPC) and 1 set of the probe kit for VIRTINS Sound Card Multi-Instrument (P601PC)
HeadsetJack-to-3RCA converter's TRRS plug pinout: Tip-left, Ring1-right, Ring2-mic, Sleeve-common ground
Introduction
The Sound Card Oscilloscope Probe is not an ordinary oscilloscope probe. It is dedicated for PC sound Card based virtual instrument software such as
Multi-Instrument.
Find out more: Manual
Probe Specifications
- Maximum Allowable Input Voltage: ±24 V
- Built-in input protection circuit ensures its output to be less than 3V at all time, provided the input voltage is within the allowable range
- Three switchable attenuation positions: 1, 2, 3, with input impedance equal to 1kΩ+sound card input impedance, 201kΩ+sound card input impedance, 10.001MΩ+sound card input impedance, respectively. Note that the sound card input impedance, either MIC IN or Line In, is card dependent and ranges from 600 Ω to 50 kΩ.
- Frequency range: 0~200 kHz
- Soft molded strain reliefs at all stress points assure long cable life.
- Accessories include sprung hook, 6" ground lead.
- Its back end is a RCA plug (male) and can be connected to an ordinary sound card through a stereo-to-2RCA converter or a mono-to-1RCA converter. No converter is required for those sound cards that have RCA jacks for input and output.
- Can be used in Signal Generator for signal output. The output impedance is about 1 kΩ, 201 kΩ and 10.001 MΩ for attenuation switch Positions 1, 2, 3, respectively.